Health & Environmental Research Online (HERO)


Print Feedback Export to File
3033511 
Journal Article 
Iron Ore Pellet Dustiness Part II: Effects of Firing Route and Abrasion Resistance on Fines and Dust Generation 
Halt, JA; Kawatra, SK 
2015 
1 
Mineral Processing and Extractive Metallurgy Review
ISSN: 0882-7508 
36 
5 
340-347 
WOS:000354545800008 
Iron ore pellets abrade during their production and handling, which lowers product quality and leads to dustiness issues. Pellets were collected from a variety of plants (operating either Straight-Grate (SG) or Grate-Kiln (GK) furnaces) to understand whether furnace type affects fines and dust formation. Results showed that pellets fired in SG furnaces were less abrasion-resistant (3.5xlower) than pellets fired in GK furnaces. Concurrently, laboratory pellets were prepared using various ores, binders, and firing temperatures. These were tested to understand the relationship between abrasion index and dustiness. AI was observed to range from 1 to 14%. Dustiness, determined via AI and size distributions of abrasion progeny, ranged from 0.2 to 1.6%. For AI greater than 5%, AI can be used to indicate potentially high levels of dust. For AI less than 5%, there was a poor correlation between AI and dustiness. This was explained by the observation that as AI decreased, the abrasion product fineness increased. The results from parts I and II of this investigation suggest that material loss and levels of pellet dustiness may be significantly affected by pellet quality up to a certain point. Poorly fired pellets will be dusty during handling and transportation, while well-fired pellets will generate less - but finer - material as their quality improves. This could lead to little observed changes in dust generation over a wide range of pellet quality. Dust generation at each site would then depend on the quantity of material produced and their extent of handling. 
abrasion; straight grate; grate kiln; dustiness; pelletization; tumble; iron ore pellets