US EPA

3843468 

Journal Article 

Carbon monoxide hydrogenation on potassium promoted Mo2N catalysts 

Zaman, SF; Pasupulety, N; Al-Zahrani, AA; Daous, MA; Al-Shahrani, SS; Driss, H; Petrov, LA; Smith, KJ 

2017 

1 

Applied Catalysis A: General
ISSN: 0926-860X
EISSN: 1873-3875 

532 

133-145 

10.1016/j.apcata.2016.12.015 

WOS:000393242500016 

The catalytic performance of Mo2N and K-Mo2N were assessed in hydrogenation of carbon monoxide in the reaction temperature range of 275-325 degrees C, 7 MPa and 60,000 h(-1). The nitrides were synthesized via temperature-programmed treatment of ammonium heptamolybdate (AHM) and K-AHM precursors under continuous NH3 flow. The influence of potassium loading (0.45-6.2 wt.%) on the Mo nitride phase and its resultant effect on the catalytic properties were been investigated. The nitride catalysts were characterized in terms of BET/pore size, powder X-ray diffraction, DRIFTs, CO-TPD-mass, HR-TEM and XPS measurements. The formation of cubic gamma-Mo2N and monoclinic K2MoO4 phases were confirmed by XRD and TEM. Platelet morphology with particle size in the range of 5-10 nm was observed for gamma-Mo-2 N. CO-TPD-mass results mainly revealed molecular CO sorption on Mo2N and K-Mo2N surface. The highest total oxygenate selectivity (44%, 300 degrees C) was observed on 1.3K-Mo2N with a K/Mo delta+ surface ratio of 0.06. This is associated with well distributed K in the matrix of gamma-Mo2N. Distribution of K was reduced due to K2MoO4 formation at 3 and 6.2 wt.% K loading. DRIFTs results clearly demonstrates greater hydrocarbon formation on unpromoted Mo2N due to (i) CO dissociative hydrogenation (ii) water-gas shift reaction. Further, addition of K to Mo2N significantly improved the oxygenate selectivity by promoting the molecular CO insertion into -CHx intermediate. (C) 2016 Elsevier B.V. All rights reserved. 

Mo2N catalysts; Alkali metal; CO hydrogenation and higher oxygenates