Health & Environmental Research Online (HERO)


Print Feedback Export to File
4866759 
Journal Article 
Measurements and interpretation of shock tube ignition delay times in highly CO2 diluted mixtures using multiple diagnostics 
Pryor, O; Barak, S; Koroglu, B; Ninnemann, E; Vasu, SS 
2017 
Yes 
Combustion and Flame
ISSN: 0010-2180 
180 
63-76 
WOS:000401682700009 
Common definitions for ignition delay time are often hard to determine due to the issue of bifurcation and other non-idealities that result from high levels of CO2 addition. Using high-speed camera imagery in comparison with more standard methods (e.g., pressure, emission, and laser absorption spectroscopy) to measure the ignition delay time, the effect of bifurcation has been examined in this study. Experiments were performed at pressures between 0.6 and 1.2 atm for temperatures between 1650 and 2040 K. The equivalence ratio for all experiments was kept at a constant value of 1 with methane as the fuel. The CO2 mole fraction was varied between a value of)(co, = 0.00 to 0.895. The ignition delay time was determined from three different measurements at the sidewall: broadband chemiluminescent emission captured via a photodetector, CH84 concentrations determined using a distributed feedback interband cascade laser centered at 3403.4 nm, and pressure recorded via a dynamic Kistler type transducer. All methods for the ignition delay time were compared to high-speed camera images taken of the axial cross-section during combustion. Methane time-histories and the methane decay times were also measured using the laser. It was determined that the flame could be correlated to the ignition delay time measured at the side wall but that the flame as captured by the camera was not homogeneous as assumed in typical shock tube experiments. The bifurcation of the shock wave resulted in smaller flames with large boundary layers and that the flame could be as small as 30% of the cross-sectional area of the shock tube at the highest levels of CO2 dilution. Comparisons between the camera images and the different ignition delay time methods show that care must be taken in interpreting traditional ignition delay data for experiments with large bifurcation effects as different methods in measuring the ignition delay time could result in different interpretations of kinetic mechanisms and impede the development of future mechanisms. (C) 2017 The Combustion Institute. Published by Elsevier Inc. All rights reserved. 
CO2; Shock tube; Bifurcation; Ignition delay time; Chemical kinetics