Health & Environmental Research Online (HERO)


Print Feedback Export to File
6871353 
Journal Article 
EXPLORING M & Y GASKET FACTORS AND THEIR DEGREE OF CORRELATION WITH PROPOSED PVRC GASKET FACTORS 
Rice, DA; Waterland, AF III; Bausman, AR; , 
2017 
AMER SOC MECHANICAL ENGINEERS 
NEW YORK 
WOS:000422810500025 
The well-known gasket factors, m & y were introduced in 1943 as per ASME Boiler and Pressure Vessel Code, Section VIII, Division 1 for purposes of flange design. The test procedure for determining these factors, ASTM Standard F586, was published in 1979 but then ultimately withdrawn in 1998 with the assumption that these test standards would be replaced by a new test method and with it the generation of improved gasket constants. The original m & y constants had several shortcomings including the fact that many of the listed values assumed asbestos fiber gaskets while new gasket materials such as PTFE (polytetrafluoroethylene) and FG (flexible graphite) were not addressed. Additionally, gasket manufacturers were allowed to publish m and y values for their own specific gasket materials and styles using their own test methods, thus dispensing with industry-wide standardization. ASTM Method F3149-15, "Standard Practice for Determining the Maintenance Factor (m) and Yield Factor (y) Loading Constants Applicable to Gasket Materials and Designs" represents an improvement over F586 but is not linked to standardized tightness levels. The proposed PVRC method with a new set of gasket constants is based on a load versus leakage test standard known as ROTT (Room Temperature Tightness Test). Following the ROTT method, ASTM WK39360, "New Test Method for Leak Rates Versus Y Stresses and M Factors for Gaskets derived from the Room Temperature Test Practice", is being contemplated. This paper provides a review of the past inconsistencies of m & y values as published as well as an initial assessment of the degree of correlation between m & y values and tightness calculations achieved through the use of a previously documented fugitive emissions calculator for gasket materials which makes use of published ROTT data, and the operating pressure, flange NPS, gasket stress, and other inputs. 
Noble, R; Reinhardt, W; AzadiBorujeni, B; 
978-0-7918-5793-9 
ASME Pressure Vessels and Piping Conference 
Waikoloa, HI