Health & Environmental Research Online (HERO)


Print Feedback Export to File
7169865 
Journal Article 
MELTING/SOLIDIFICATION ANALYSIS OF THE PB FREE-SOLDER IN SLEEVE SOLDERING 
Imanishi, Ken; Nomura, H; Ebisawa, M; Tsuji, K; Enoki, S; , 
2016 
AMER SOC MECHANICAL ENGINEERS 
NEW YORK 
WOS:000379702900026 
Automatic soldering technic called Sleeve soldering has been developed recently. In the technic, a ceramic tube has been used instead of a soldering iron. It is called Sleeve. Fixed amount of solder is loaded into this Sleeve. The melted solder is poured from tip of the Sleeve to glue electronic parts into electronic boards. At present Sleeve soldering has been produced and introduced. However condition of soldering failure and concept of process design are not clear due to a few data of melting behavior and solidification. In this research we intended to express these standards by comparing numerical analysis and experiment. Moreover we explain about the establishment of numerical analysis method in this paper.Result in the behavior using the solder model has been similar to actual phenomenon in this simulation. Besides, we have confirmed that the fillet and back fillet was arisen on both sides of the electronic board. 
978-0-7918-5735-9 
ASME International Mechanical Engineering Congress and Exposition (IMECE2015) 
Houston, TX